• This tester kit is used for checking the radiator to see if any water leaked because of the body or the connector not fitted properly or any broken. It is tested through pressure increase by using an adapter for closing the master or second inlet of the radiator the pushing the manual pump by hand.
• Contents:
# 0:Needle Thermometer
# 1:Manual pump with quick joint & release valve
# 2:Universal adapter with 3 rubber rings (used for cars not listed on Nos. 3-5) (See Fig.1,2,3)
• Operation:
1.According to the type of car, choose a suitable adapter and screw it in the inlet of radiator then have the manual pump pressure increased to 15-20PSI and stay the level 5-10 minutes for checking.If the pressure in the meter lower automatically, then check the body of radiator or the connector joint to see if any leaked. If the pressure is kept same, then the radiator is in good condition.
2.Before using No. 2 universal adapter, be sure to clear up the inlet of the radiator then cheak its size and appropriate rubber ringto fit then screw securely to the inlet of the radiator. Before loosening the adapter and the manual pump, be sure to leak out the
pressure to prevent the water coming out from the radiator.
• Warning:
1.While the water in the radiator stay in high temperature, please do not open the lid of radiator to prevent hot water come out.
2.While No. 2 universal adapter is used, the pressure in the manual pump must be not above 15-16PSI to prevent the adapter shut off because of high pressure.
3.While testing, if the pressure in the meter go lower but no water is leaked, then be sure to check the adapter if any not closed securely or the pump is broken.
d inlet of the radiator the pushing the
manual pump by hand.T